Shure P9HW Guide De L'utilisateur page 6

MixMode
To operate in MixMode, enter the menu and select AUDIO > MODE > MIXMODE.
In MixMode, the blend between two monitoring mixes (an instrumental mix and
a vocal mix, for example) is adjustable. The signal is mono, which means each
mix is heard through both the left and right earphones.
Adjusting mix blend
To adjust the blend between channel 1 and channel 2, enter the menu and
select AUDIO > BAL MX. Use the arrow buttons (▲▼) to make adjustments.
In this scenario, an instrumental mix is on channel 1 (left) and a vocal mix is on
channel 2 (right):
MIXMODE
10L
Instruments Vocals
To hear more of channel
one (instruments), shift the
balance towards the left.
MIXMODE
10R
Instruments Vocals
To hear more of channel
two (vocals), shift the
balance towards the right.
Balance and Mix Adjustments from the Home Screen
To make quick adjustments to the stereo balance or mixmode blend, use
the arrow buttons (▲▼) while in the home screen. If necessary, use the lock
feature to prevent any accidental adjustments.
Shure SB900 Rechargeable Battery
Shure SB900 lithium-ion batteries offer a rechargeable option for powering
the bodypack. Batteries quickly charge to 50% capacity in one hour and
reach full charge within three hours.
Single chargers and multiple bay chargers are available to recharge the
Shure batteries.
Caution: Only charge Shure rechargeable batteries with a Shure battery
charger.
Single Bay Charger
The SBC-100 single bay charger offers a compact charging solution.
1. Plug the charger into an AC power source or USB port.
2. Insert a battery into the charging bay.
Instruments
3. Monitor the charging status LEDs until charging is complete.
Charging Status LED
Vocals Color
Red
Green
Amber Flashing
Off
Vocals
Multiple Bay Chargers
Instruments Shure offers three models of multiple bay chargers:
• SBC200 two bay charger
• SBC210 two bay charger
• SBC800 eight bay charger
Multiple bay chargers can charge individual batteries or batteries installed in
bodypacks.
1. Plug the charger into an AC power source.
2. Insert batteries or transmitters into the charging bay.
3. Monitor the charging status LEDs until charging is complete.
4
Status
Charging
Charging Complete
Fault: check
connections and
battery
No battery in bay
LED