Shure P9HW Guide De L'utilisateur page 5

Audio Settings
MODE
STEREO: Audio from channel 1 is heard on the left earphone; audio
from channel 2 is on the right earphone.
MIXMODE: Both channels are heard on the left and right earphones.
The blend between mixes is adjustable.
EQ
The parametric equalizer is divided into four frequency bands:
LOW, LOW MID, HIGHMID, and HIGH. When the equalizer is enabled, the
following parameters are adjustable:
FREQUENCY: Select the center frequency of the band to boost/cut
Q: Adjusts the width and slope of the frequency
band (measured in octaves)
GAIN: Adjustable in 2 dB increments from -6 dB (cut) to +6 dB (boost)
Note: HIGH
and LOW are shelf filters, and therefore do not have adjustable
Q widths. The shelf is fixed at 10 kHz; the
HIGH
LOW LOW-MID
15
10
5
+6 dB
dB
GAIN
0 Q
-6 dB
-5
-10
-15
20 100
FREQUENCY
(Maximum Volume)
VLIMIT
Set a value (-3 to -21 dB) to attenuate the highest possible volume
level. Turning the volume knob through its entire range of motion still
affects volume; the limit simply narrows the range of dB adjustment.
Note: not
The does compress the audio.
VLIMIT
(Balance)
BAL MX / BAL ST
The behavior of the balance control depends on which mode the
bodypack is set to:
STEREO: Adjusts the left/right balance
MIXMODE: Adjusts the blend between channel one and channel two
INPUT
Line (+4 dBu): Use with mixers and other professional devices that
send a line-level signal
AUX (-10 dBV): Use with consumer electronic devices, such as MP3
players or computers.
shelf is fixed at 100 Hz.
LOW
HIGH-MID HIGH
1k 10k 20k
(Hz)
= Selectable frequencies
Utilities
CONTRAST
Customize the display screen contrast by selecting a setting between
low and high
LOCK PANEL
Locks all controls except the volume knob to prevent accidental changes
to settings
Lock: Select UTILITIES > LOCK PANEL
Unlock: Press the exit button and select OFF when the
lock setting screen appears. Press enter to confirm.
BATTERY
Displays remaining battery runtime (hours:minutes), health, temperature,
status, cycle count, and voltage.
RESTORE
Restores bodypack to factory default settings
AUTO OFF
Automatically turns off the bodypack after a selectable amount of time
(5, 30, or 60 min.) while it is in power-save mode or when connected to a
charger with the power on. To restore power to the bodypack, the power
switch must be turned off and then on again.
Note: SB900 batteries charge fastest when the bodypack is off
MixMode and Stereo Monitoring
The bodypack can operate in either of the following listening modes:
Stereo (default)
To operate in stereo mode, enter the menu and select AUDIO > MODE >
STEREO .
In stereo mode, audio from channel 1 is heard on the left earphone, while
audio from channel 2 is heard on the right earphone. Listening in stereo
increases clarity and separation between the sources on each channel.
Left (Channel 1) Right (Channel 2)
Adjusting Balance
To adjust the left/right balance, select AUDIO > BAL ST. Use the ▲▼ buttons
to change the setting.
3