Publicité
Les langues disponibles
Les langues disponibles
1. SAFETY INFORMATION
For your safety and correct operation of the appli-
ance, read this manual carefully before installation
and use. Always keep these instructions with the appli-
ance even if you move or sell it. Users must fully know
the operation and safety features of the appliance.
The wire connection has to be done by specialized
technician.
• The manufacturer will not be held liable for any damages
resulting from incorrect or improper installation.
• The minimum safety distance between the cooker top
and the extractor hood is 650 mm (some models can be
installed at a lower height, please refer to the paragraphs
on working dimensions and installation).
• If the instructions for installation for the gas hob specify
a greater distance, this must be respected.
• Check that the mains voltage corresponds to that indi-
cated on the rating plate fixed to the inside of the hood.
• Means for disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules.
• For Class I appliances, check that the domestic power
supply guarantees adequate earthing.
• Connect the extractor to the exhaust flue through a pipe
of minimum diameter 120 mm. The route of the flue must
be as short as possible.
• Regulations concerning the discharge of air have to be
fulfilled.
• Do not connect the extractor hood to exhaust ducts car-
rying combustion fumes (boilers, fireplaces, etc.).
• If the extractor is used in conjunction with non-electrical
appliances (e.g. gas burning appliances), a sufficient de-
gree of aeration must be guaranteed in the room in order
to prevent the backflow of exhaust gas. When the cooker
hood is used in conjunction with appliances supplied with
energy other than electric, the negative pressure in the
room must not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker hood.
• The air must not be discharged into a flue that is used
ENGLISH
3
Publicité
