ECO WEEDKILLER EWK25 Garden Manuel D'utilisation page 8

WARNING!
Always completely fill the device with water before heating it. If the device is heated
without water or with too little water, it will overheat and be damaged. Fire hazard!
LOOK OUT!
If the filler cap is not tightened properly, or it is misaligned, there may be some
steam coming from under the filler cap when device is heating / hot. Tighten the
filler cap until steam is no longer leaking.
LOOK OUT! If the pressure inside the device increases too much, the excess pressure is released
through the safety valve. During that there might be some steam coming out under
the machine and a loud rustle noise be heard. This is completely normal function of
that safety valve.
LOOK OUT!
The use of gloves is recommended.
NOTE! Do not use sea water or salted water! Always prefer clean or filtered water. The use of
surface or collected water is allowed but filtering is recommended.
NOTE! Do not add any chemicals or substances into the tank!
NOTE! Do not re-heat the water before the tank is filled again.
NOTE! The device is heavy, follow extreme caution when moving with the device.
NOTE! If the use of extension cord is required for powering the product, make sure it is suitable
for rated current (16 A or 10 A, check products CE-sticker and chapter 9. Technical data). If
uncertain, contact the dealer for technical support.
Step by step operation instructions
To operate the device, follow these step-by-step instructions below. See also the quick start
instruction sticker.
STEP 1: Open the filler cap and add water until the tank is completely full. Use clean/filtered
water. Do not use sea water! Tank is full when the water level is clearly seen from the
filling neck. If tank is overfilled, excess water will leak out of the pressure lock and the
filling neck (picture A, no. 8).
STEP 2: Screw in the filler cap and lightly tighten until you feel resistance. Then tighten the
filler cap 1-2 more slots. Make sure that the pressure lock is visible in the middle of
the filler cap slot as shown in image C.
Insert power plug to socket. Heating will automatically start. Red light indicates that
STEP 3:
heating is on, green indicates that the power plug is inserted, and power is on. If the
use of extension cord is required to power the product, make sure it is suitable for
rated current (see chapter 9. Technical data).
If steam is leaking under the filler cap when the device is heating, slightly tighten the
filler cap. If this doesn't help, remove power plug from socket and wait until the
device is cooled down. Then tighten the filler cap and repeat step 3 and continue to
steps 4 and 5.
WARNING! Never open or attempt to open the filler cap when the device is hot or
warming up!
7
English