wolfpack 07021655 Manuel D'instructions page 17

• Ensure that the appropriate grinding wheel and the other parts are installed in accordance
with the manufacturer's instructions. It must also be ensured that the grinding wheel that is to be
used is of the correct model and that it has no cracks or surface defects. It must also be ensured
tightened. See section "installing the grinding wheels".
• Ensure that the recommended washers are used when they are delivered with grinding wheels
made from bonded abrasives.
• Do not use separate bushing or adaptors to adjust grinding wheels with a large hole.
• Do not use a cut-off wheel for side-grinding.
secured, and let the machine run without a load for 30 seconds in a secure location. Stop the
machine immediately if considerable vibrations occur, or if malfunctions can be determined. If
OPERATION
• Always wear safety-goggles during your work.
• Hold the angle grinder with both of your hands on the provided handles.
• When switching ON make sure, that the grinding wheel does not touch the workpiece.
• Do not start the cutting or grinding process until the machine has reached its full speed.
SWITCHING ON / OFF
• To start the power tool, push the on/off switch (3) forward.
• To lock the on/off switch (3) in position, push the on/off switch (3) forward and down until
it clicks into place.
• To switch off the power tool, release the on/off switch (3); or, if the switch is locked,
• ATTENTION: Disc will run out slowly!
• Pull down the angle grinder only after the disc has come to a complete stop.
RESTART PROTECTION
• The restart protection feature prevents the power tool from uncontrolled starting after
the power supply to it has been interrupted.
• To restart the tool, set the on/off switch (3) to the off position and then switch the
power tool on again.
17