Publicité
Les langues disponibles
Les langues disponibles
7.2
Removing SDS-max tool
Pull back fastening sleeve, hold and remove tool.
Accessories can be hot after use. Don't touch the tip of accessory by hand!
Please always use protective floves to remove accessory.
8 OPERATION
8.1
Switching ON/OFF
When the power cord is plugged in, the power light will illumine until you disconnect the tool
from the mains.
▪
Switching on:
▪
Switching off:
8.2
Handle attachment (Fig. 3)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop onto the neck
of the housing tool and position the handle, then tighten the handle attachment.
8.3
Dust collection device (Fig. 4)
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
8.4
Hammer / drill switch
▪
The hammer/drill switch can switch to drill, hammer and hammer/ drill functions.
▪
There is a lock knob in front hammer/ drill switch, please depressed it first to preventing
any unintentional adjusting.
▪
To set the function, please use below:
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Copyright © 2022 VARO NV
Press the operating switch (9).
Release the operating switch(9)
POWP3030
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic tile or
others material can not withstand impact energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Chisel Rotation:
Non-working position used only to rotate flat chisel
into the desired position
P a g e
| 6
EN
www.varo.com
Publicité
