Télécharger Imprimer la page

Anslut 027402 Traduction Des Instructions D'origine page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
1
Introduction
1.1
Product description
The product is a light sensor to be installed on Anslut street
lights 027400 and 027401. With the product installed, the
light goes on automatically when the light level falls below
the set lux level. The product is for outdoor use only.
1.2
Symbols
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
2
Safety
2.1
Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read the warning instructions that follow before you use
the product.
● Before installation, the power must be turned off. Turn off
the circuit breaker or disconnect the fuse to turn off the
power.
● The product is only intended for outdoor use.
● Do not allow children to play with the packaging material
or the product.
● Repairs must be carried out by an authorized electrician.
● Do not attempt to modify or repair the product. Repairs
that are not carried out correctly can result in a risk of
serious personal injury and/or death.
8
● Do not use the product if it is damaged.
● Do not modify the product.
● The product must only be used for its intended purpose.
3
Installation
3.1
To install the product
(Figure 1)
1
Attach the product to the sensor base on the street
light (A).
2
Turn the product clockwise to secure it (B).
3.2 Wiring diagram
A.
Photo control
B.
Receptacle
C.
Black
D.
White
E.
Red
F.
Electricity supply
G.
Terminal block
H.
Ballast/driver
4
Maintenance
● If needed, clean the product with a damp cloth.
5
Disposal
5.1
To discard the product
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.

Publicité

loading