Buffalo CU485 Mode D'emploi page 5

Overheat protection function
If the pan becomes too hot the appliance will switch off, a buzzer will sound and the display will show "E2".
Should this happen, allow the appliance to cool before restarting.
Cleaning, Care & Maintenance
• Disconnect from the power supply and allow the appliance to cool before cleaning and maintenance.
• Use warm, soapy water and a damp cloth to clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
Do not use the glass surface for storage purposes.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not working
"E0" on Display
"E1" on Display
"E2" on Display
"E3" on Display
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage
220-240V~
CU485
50-60Hz
220-240V~
CU486
50-60Hz
CU485-CU486_ML_A5_v2_20230602.indb 5 CU485-CU486_ML_A5_v2_20230602.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Unsuitable cookware
Unsuitable cookware / no
cookware
Appliance has overheated
Temperature of pan is too
high (Pan is dry or empty)
Input voltage is too high/
low
Power Current
1000W 5A
1000W 5A
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Replace with suitable cookware
Replace with suitable cookware
Check ventilation slots for blockage. Allow to
cool before attempting to use again
Remove cookware. Allow to cool before
attempting to use again
Make sure the mains power supply is suitable
for the appliance
Operating Dimensions
frequency h x w x d (mm)
21-24kHz 61 x 462 x 335
21-24kHz 61 x 530 x 325
EN
Weight
5.01kg
6.81kg
5
2023/6/2 11:47:07 2023/6/2 11:47:07