Publicité
Les langues disponibles
Les langues disponibles
Symptom
Remedy
No Bluetooth device
• Search from the Bluetooth device again.
is detected.
• Reset the unit. ( 3)
Pairing cannot be
• Make sure you have entered the same PIN code to both the
made.
unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 13)
"PAIRING FULL"
The number of registered devices has reached its limit. Retry
appears.
after deleting an unnecessary device. ( 17, DELETE PAIR)
"PLEASE WAIT"
The unit is preparing to use the Bluetooth function. If the
appears.
message does not disappear, turn off and turn on the unit,
then connect the device again.
"BT DEVICE NOT
The unit failed to search for the registered Bluetooth devices
FOUND" appears.
during [AUTO CNNCT]. Turn on Bluetooth from your device
and connect manually. ( 17)
Echo or noise occurs.
• Adjust the microphone unit's position. ( 13)
• Check the [ECHO CANCEL] setting. ( 15)
Phone sound quality
• Reduce the distance between the unit and the Bluetooth
is poor.
device.
• Move the car to a place where you can get a better signal
reception.
"NOT SUPPORT"
The connected phone does not support Voice Recognition
appears.
feature.
"ERROR" appears.
Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
Symptom
The unit does not respond
when you try to copy the
phonebook to the unit.
Sound is being interrupted or
• Reduce the distance between the unit and the
skipped during playback of a
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect
• Other Bluetooth devices might be trying to connect
The connected Bluetooth
• Check whether the connected Bluetooth audio
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
"H/W ERROR" appears.
"BT ERROR PLS UPDATE"
appears.
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit ( 3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
TROUBLESHOOTING
Remedy
You may have tried to copy the same entries (as
stored) to the unit. Press DISP or G PTY to
exit.
Bluetooth audio player.
again.
to the unit.
player supports Audio/Video Remote Control Profile
(AVRCP). (Refer to the instructions of your audio
player.)
Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service
center.
Update the Bluetooth firmware. ( 4)
ENGLISH |
25
Publicité
