TREVIDEA G3FERRARI G20162 Manuel D'utilisation page 11

Do not let the appliance running continuously for more
than 2 minutes, make at least 5 minutes rest.
Never exceed the maximum quantity indicated on the
container. When processing fruits, it is recommended to
remove the pit and peel.
For a better cleaning, it is recommended using warm tap
water and restricting the use of detergents. In this case,
rinse thoroughly. Do not immerse the motor unit in water
or other liquids; clean the motor housing with a damp
cloth. Blades and rostrum are very sharp: be careful
not to cut yourself during cleaning or when removing
the accessories.
A. Measuring cup
E. Joint
OPERATING
1) Place the motor unit (G) on a flat and stable surface.
2) Insert the glass (D) on the motor unit (G). Make sure the assembling has taken place in a correct way,
since otherwise the safety device inhibits the product from running.
3) Place the food in the container (D) without exceeding maximum capacity of 1500ml.
4) Lower the lid (B) correctly above the container.
5) Connect the power plug and switch on appliance with the knob (H). This blender has 2 speeds and the
PULSE function.
6) During use, always keep the lid close, in the case some food blocks the blades from running, unplug the
device before removing it.
For best results, process food first at lower speed, then at the highest. The blender is ideal for making
milkshakes, smoothies, sorbets, sauces, creams, cocktails etc... This appliance is not suitable for crushing ice,
frozen foods, cereals, rice and coffee, as they may damage the blades.
SAFE MODE
This model has a safety device: the device only works if the container (D) is properly inserted into the motor
block (G). If the glass is removed, or if it is not properly inserted, the motor stops. If it happens, properly
assemble the glass container.
FIRST USE
Remove and install the glass few times without plugging the unit or adding fruits or vegetables. Follow these
steps to make practice. Wash the lid and the jug with warm water and dishwashing liquid. Other accessories
with electrical parts, such as the motor block, must be cleaned with a damp cloth and dry immediately.
CLEANING -
Disconnect the power plug from the electrical outlet.
Do not immerse the motor unit in water, but wash it with a damp cloth and non-abrasive detergent. Also
avoid any infiltration of water into the motor housing. Container, blades and lid can be washed like everyday
crockery with non-abrasive sponge and mild detergent or in a dishwasher. Dry them thoroughly, before
assembling them to the unit. For a quick cleaning, fill up half the glass with tap water and and turn on the
DESCRIPTION G20162
B. Lid C. Cover seal
F. Blades G. Motor unit
D. Gradueted container
H. Power knob
10