Télécharger Imprimer la page

Mi-T-M Corporation AG2-SV14-30M Manuel De L'opérateur page 25

Publicité

Les langues disponibles

Les langues disponibles

ENGINE:
The engine for this unit is governed to operate at speeds close to 3600 RPM
(60Hz) throughout the operating load range.
WARNING: DO NOT TAMPER WITH THE GOVERNOR MECHANISM,
CHANGE THE SETTING EXPERIMENTALLY, OR PUSH THE
THROTTLE OPEN IN AN ATTEMPT TO GENERATE MORE
ELECTRICAL CURRENT; EQUIPMENT DAMAGE OR PERSONAL
INJURY MAY RESULT.
GOVERNOR SPEED ADJUSTMENT SHOULD BE MADE ONLY BY
A JOHN DEERE SERVICING DEALER.
CHECKING ENGINE OIL:
Check oil level before each operation and ensure that it is maintained per
engine manual.
CHANGING ENGINE OIL:
Change oil after the first 25 hours of operation. Thereafter it should be
changed every 50 hours.
1. Make sure the unit is on level ground. Run the engine to warm the oil.
2. Stop the engine.
3. Remove the oil drain plug. (See Fig. 1)
CAUTION: OIL BEING DRAINED MAY BE HOT. TO REDUCE THE
RISK OF BURN INJURY, HANDLE WITH CARE. DISPOSE OF
USED OIL PROPERLY.
4. Drain oil while engine is warm, into a suitable container.
5. Reinstall the oil drain plug.
6. Remove oil gauge and refill with new oil. (Fig. 2)
7. Check the oil level as instructed in the engine manual.
8. Wipe up any spilled oil.
AIR CLEANER:
WARNING: RISK OF FIRE OR EXPLOSION. DO NOT USE GASOLINE
OR LOW FLASH-POINT SOLVENTS TO CLEAN THE ELEMENT.
CLEAN THE ELEMENT IN A WELL VENTILATED AREA. ENSURE
THAT NO SPARKS OR FLAMES ARE NEAR THE WORKING
AREA, THIS INCLUDES ANY APPLIANCE WITH A PILOT LIGHT.
CAUTION: NEVER RUN THE ENGINE WITHOUT THE AIR FILTER,
SERIOUS DANGER CAN RESULT.
Check the air cleaner daily or before starting the engine. Check for and cor-
rect heavy buildup of dirt and debris along with loose or damaged compo-
nents.
1. Unscrew the air cleaner cover and remove the elements.
2. Clean the element:
PAPER AIR CLEANER ELEMENT: Do not wash the paper element or use
pressurized air, as this will damage the element. Clean by gently tapping the
element to remove dust. Replace the element if damaged, bent or extremely
dirty. Handle new element carefully; do not use if the sealing surfaces are
bent or damaged.
NOTE: Replace the paper element every 100 hours (more often under
extremely dusty conditions.)
3. Reinstall the paper air cleaner element. Close air cleaner cover and screw shut.
Operator's Manual
MAINTENANCE
25
OIL DRAIN PLUG
(Fig. 1)
UPPER LEVEL
(Fig. 2)

Publicité

loading