TREVIDEA G3 FERRARI SMART CUT Mode D'emploi page 11

- Never leave unattended while it is running.
- Do not wrap the power cord around the unit during use.
Pay attention to the power supply. An incorrect
voltage may damage the motor and jeopardize the
functionality of the device.
DESCRIPTION G30063
1. Blade
5. Charging light
9. Small brush
OPERATING
The hair clipper can be used both weather it is connected with the USB cable or not.
WARNING: if during battery working the appliance stop working, put switch (4) in OFF position, connect
USB cable (8) to a proper USB charger and to connector (6). Wait one minute before starting again operation.
HOW TO USE
- Keeping off the unit, mount the supplied comb (7). Choose the length of cut you wish to obtain with the
regulator (3) (from 1 to 20 mm). Turn on the clipper with the ON/OFF button (4) and start cutting.
- Once finished cutting operation, turn off the device using the power button (4), remove the comb and store
the clipper and its accessories out of the reach of children.
RECHARGING
When you first use the product fully charge it, leaving it connected for at least 1.5 hours.
To recharge, connect the USB cable (8) to a suitable USB socket (PC, USB charger, power bank....) and into
the connector on the rear of product (6).
During charging the LED (5) is red. When battery is fully charged, it becomes blue.
The following measures will preserve the battery life.
At first use the product fully charge the product, leaving it connected for at least 1.5 hours. Before you
recharge, completely discharge the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 1.5 hours
before using. In any case it is advisable to fully discharge the battery before recharging. If the appliance, even
after a recharge, works only if it is connected to the USB, it is possible that the battery is no longer capable of
delivering enough power to the unit. In this case, please contact an authorized service center.
LOCK
Press for 3 seconds the ON/OFF button (4) to block functioning. The light (12) switches on and the button (4)
does not turn on the clipper. Press for 3 seconds the ON/OFF button (4) to unlock.
MAINTENANCE AND CLEANING
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them or using the small
brush (9). The light (11) remembers (every 60 minutes use) to lubricate and clean the blade by following the
steps below. Extract the blade set (2) by pulling it up as shown in figure. Remove remaining hair by blowing
or using the small brush (9).
Use lubricating oil (10) for the blade. 2 or 3 drops are enough if this operation is carried out frequently. Two
points must be lubricated with oil: Put 1-2 drops on the blade. Put 1-2 drops on the driveshaft joint. Use only
the provided oil or similar oil without acids.
Clean the main body by using a soft damp cloth, never immerse the unit in water or other liquids.
2. Removable blade set
6. Charging input
10. Lubricating oil
3. Cutting regulator
7. Separating comb
11. Cleaning light
4. On/off button
8. USB cable
12. Lock light
10