JAPANNEXT JN-IPS3200WQHD Manuel D'utilisation page 6

QUICK START GUIDE
Put the monitor face down on a stable and smooth surface, pay attention not to damage or scratch the front glass /
screen. It's better putting a soft piece of cloth on the table beforehand to protect the monitor. Make sure the monitor
is unplugged before starting installation.
SETTING UP THE MONITOR
1. Put the monitor face down on a stable and smooth surface.
2. Put the stand against monitor back and use 4 screws (included) to firmly attach the stand to the monitor (Pic-1).
3. Close the cover (Pic-2)
4. Use the big screw (included) to fasten firmly the base to the stand (Pic-3).
5. Make sure the stand and base are firmly attached (Pic-4).
6. Make sure both monitor and computer are unplugged.
7. Plug power cord and signal cable (HDMI or VGA or DP etc.. ) to the monitor.
8. Plug the computer and monitor power cord to the power supply.
7. Turn on the monitor and computer.
*The base can be removed in reverse order
NOTE / CAUTION
After turning on computer and monitor if no image is displaying make sure your have chosen the right signal cable.
Please fasten signal cable finger screws at each end of cable (only VGA).
6
Please make sure to earth the power cord.