flow-med vac-clean uv 2 Mode D'emploi page 4

EN INSTRUCTION FOR USE
Initial operation
1. Plug the USB cable into a USB power supply (5V/1A) and the USB-C plug into the USB-C socket of your
vac-clean uv 2®.
2. Then plug the power supply unit into a mains socket. i LED 1 flashes green
• The vac-clean uv 2® is charged in approx. 2.5 hours and runs for approx. 2.5 hours. i LED 1 lights up green
Operation with the attachment head
3. Insert the attachment head suitable for your cleaning purpose into the base attachment.
4. Briefly touch the I/O button and the vacuum motor starts at the strongest suction level (ooo).
i LED 2 lights up (ooo)
• The blue LED light starts automatically for better illumination of the areas to be cleaned.
i LED 3 lights up
• Move the vac-clean uv 2® with light pressure over all areas to be cleaned and vacuum up the dirt.
5. Once cleaning is complete, switch the appliance off by touching the I/O button for at least 3 seconds. Otherwise
the device will automatically switch-off after 4 minutes.
i all LEDs turn off
2