Peavey PV 215 EQ Mode D'emploi page 8

Les langues disponibles

ENGLISH

215EQ

Graphic Equalizer

Description

Thank you for purchasing a Peavey Electronics PV 215EQ graphic equalizer.The PV 215EQ is a dual-channel EQ incorporating

Peavey's legendary low-noise, low-distortion design. Ruggedly constructed, PV 215EQs have center-detented fader controls, with

±12 dB gain and an LED display indicating level. Other features include balanced inputs and outputs and bypass switches.Whether

on stage, in the studio or simply tweaking your home hi-fi system, the PV 215EQ is the EQ for you.

Features

➡ Dual channel (15 bands per channel)

➡ 2/3 octave filter sets

➡ 25 Hz to 16 kHz effective equalization range

➡ Constant Q filters

➡ 12 dB cut or boost per band

➡ Level LEDs (-12 to +17 dB)

➡ Low cut filter switch with status LED

➡ XLR inputs and outputs for balanced operation

➡ Bypass switch with status LED

➡ Ground lift switch

Equalization Process

Always begin the equalization process with all sliders at their center-detent (flat response) positions. Adjust the level up until the

unit begins to feed back, then lower each fader until the feedback frequency is found. Lower the faders in small amounts to avoid

adversely affecting sound quality. Likewise, excessive boosting of a frequency may result in feedback.

Exercise caution when attempting to boost frequencies below speaker system transducer cut-off.Typical sound reinforcement

enclosures are not designed for 20 Hz performance, and transducer damage could result from over-boosting low frequencies.

Excessive boost at very low frequencies could also limit overall system headroom. Engaging the low-cut filter is the best way to

avoid these problems.

NOTE:

Superb tonality, absence of feedback and great-sounding systems may not be achievable with any graphic equalizer. All

other system components must be of high quality and designed for the application. No amount of equalization will correct an

acoustically bad room or bad microphone/speaker arrangement, or completely correct the response curve of a poor loudspeaker.