BorMann PRO BIW1310 Mode D'emploi page 7

EN
INSTALLATION
Pre-installation checks
• The welding equipment is equipped with a power voltage compensation set. When the power voltage changes between ±15% of rated voltage, it still works
normally.
• When using a long cable, make sure it has a big section in order to minimize voltage reduction. If the cable is too long, it will affect arcing performance and
other system functions, so make sure to use the suggested cable length.
• Make sure the intake of the machine is not covered or blocked to prevent the malfunction of the cooling system.
• Use an earth cable with a section no less than 6 mm
the earth end of the power switch reaches the earth. Both ways can be used for better security.
Installation steps
1. Connect the gas flask with CO2 decompression flow meter and the CO2 mouth behind the machine via gas cable.
2. Insert the swift plug of earth cable into the swift socket in the front panel.
3. Set the wire wheel with wire on the wheel axis, the wheel hole should be matched with the wheel fixer.
4. Choose wire slot according to wire size.
5. Loosen the screw of wire-pressing wheel, put the wire into slot via wire-lead tube, tune the wire-pressing wheel to fix wire from gliding, but pressure should
be suitable in case the wire distorts and affects wire sending.
6. Wire roll should turn clockwise rotation to let out wire, to prevent wire from gliding, wire is usually set to the fixed hole on the wheel side.
7. Insert the wire into the MIG torch by hand.
OPERATING INSTRUCTIONS
1. Set the air switch to the "ON" position, open the valve of CO2 cylinder and adjust the flow.
2. Adjust the wire diameter of the wire machine to rated number according to wire diameter.
3. Choose torch loophole span based on wire diameter.
4. Tune the voltage knob, speed knob and inductance knob to the right position based on the thickness of the work piece and mechanics.
5. Press the torch switch to let out the wire to the torch head and begin working.
WELDING TIPS
• Fittings, welding materials, environmental factors and supply voltage may affect the welding quality. It is important to maintain a good welding environment.
1. Arcing-striking is difficult and easy to pause
• Ensure that the earth cable clincher connects the work piece well.
• Ensure that all connecting points are well connected.
2. Output current does not reach rated value
• When supplied voltage is lower than the rated, the maximum output current will be lower than the rated.
3. Current is not stabilizing during operation
• Electric wire net voltage has been changed.
• There is harmful interference from electric wires or other equipment in close proximity.
MAINTENANCE
Warning: Before any maintenance work on the device, power must be turned off and the power plug must be removed from the socket.
• Remove dust with dry and clean compressed air regularly. Pressure of compressed air must not be too high so as to not damage components.
• Check the internal circuit of the machine regularly and ensure that the cables are well connected and all connectors are connected tightly (especially insert
connectors and components).
• Avoid water and steam entering the machine. If the unit comes into contact with water, do not use it.
• If the welding machine is not to be operated for a long period, it must be stored in a dry, clean place.
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
7
to connect the housing and earth. Connect the back of the machine to the earth set, or make sure that
2
WWW.NIKOLAOUTOOLS.COM