Publicité
Les langues disponibles
Les langues disponibles
Please read the user's manual carefully before the installation and the first operation
of the amplifier.
SPECIFICATIONS
Subwoofer
Output Power RMS
Output Power Max
Frequency Range
Lowpass Filter
Subsonic Filter
Phase Shift
Bass Boost
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
WARRANTY
This product meets the current EU minimum warranty requirements, if purchased in countries of the EU. To en-
sure your warranty policy keep your original receipt proofing the date of purchase. Any damage to the product
as a result of misuse, abuse, accident, incorrect wiring, improper installation, alteration of date code or barcode
labels, revolution, natural disaster, or any sneaky stuff because someone messed up, repair or alteration out
side of our factory or authorized service centers and any thing else you have done that you should not have
done is not covered. This warranty is limited to defective parts and specifically excludes any incidental or con-
sequential damages connected therewith.
IMPORTANT NOTES PRIOR TO INSTALLATION
• This device is only suited for a 12 volt system with negative ground.
• The radiated heat while operation requires sufficient air circulation at the place of installation. It is very im-
portant that the heat sink fins do not have contact with any metal parts or any surfaces which could impair
air circulation. The amplifier may not be installed in small closed location or spaces without air circulation.
We recommend the installation in the vehicle's trunk. Ensure sufficient protection against vibrations, dust
and dirt.
• Ensure that the input and output cables are sufficiently separated from the power supply cables. Otherwise
interferences may occur.
• Ensure the accessibility of the fuse and the operating elements after installation.
• The reliability and performance of the amplifier depends on the quality of installation. Preferably consult an
expert to install the system.
• Avoid any damage or removing of the components of the vehicle like wires, cables, board computer, seat
belts, gas tank or the like.
V1100A
28 cm (11")
1 x 150 W
1 x 300 W
20 – 150 Hz
50 – 150 Hz
Fixed at 20 Hz
0° / 180°
0 – 12 dB @ 45 Hz
+12 V (9 – 15 V), negative ground
25 A
Ø 360 x 145 mm
7
Publicité
