Technical Data; Simplified Eu Declaration Of Conformity - Inverto HOME Pro Manuel D'installation

Connecting the antenna cable to the LNB
1. Attach the protective rubber boot to the antenna cable.
2. Strip the cable insulation and screw the F-plug* onto the end of
the cable (Fig. 4).
3. Make sure the braided wires and the center conductor are not
touching each other as this degrades signal quality.
4. Screw in the F-plug to connect the antenna cable to the LNB.
5. Slide the protective rubber boot into its collar tip at the LNB
housing.
* F plug is sold separately. It is not included with the LNB.

Technical data

Parameter
Input signal
Output signal
Local Oscillator (L.O.)
Cross polarization isolation
Output ports / impedance
Input DC voltage level
DC current consumption
Neck diameter (Ø)
Weight
Item# 5441/5442/5443/5444/5479
GHz 10.7 ~ 12.75
MHz 950 ~ 2150
GHz 9.75 (low band), 10.6 (high band)
dB 23dB typical
-/Ω 1/2/4/4/8 F-type ports / 75
VDC 11 ~ 20
mA 100/150/300/240/300 max.
mm 40
g 83/98/126/126/276
7 mm
10mm

Simplified EU Declaration of Conformity

FTA Communication Technologies S.á r.l hereby
declares that the LNB converter type 5441 / 5442 / 5443 /
5444 / 5479 meets the essential requirements of the following
directives:
- RED 2014/53 / EU
- RoHS 2011/65 / EU
A copy of the full text of the EU declaration of conformity can be
found at: www.inverto.tv/support_dc
Fig. 4
En
4