Inverto HOME Pro Manuel D'installation page 3

Installing the LNB on the dish antenna
1. Place the LNB in the LNB holder/clamp of the dish antenna. Close the
LNB holder handle and lightly tighten the clamp screw so that the
LNB can still rotate (Fig. 1).
2. Set the correct tilt angle of the LNB by rotating the LNB clockwise
or counterclockwise: The tilt angle of the LNB (K) depends on the
location of the satellite dish antenna installation and the satellite to
be received. For example, for receiving Hotbird at 13°E in Warsaw,
the tilt angle of the LNB should be 6° counterclockwise. Fine angle
adjustment turning should be done using a satellite signal meter or
a satellite receiver measurement indications (Fig. 2).
3. After determining the correct position of the LNB, tighten screws
that secure the LNB clamp so that the LNB is fixed in its place (Fig. 3).
4. The above description of the LNB installation applies to the case
when the satellite dish is correctly installed and aligned towards the
desired satellite. In other cases, you must complete the installation
and correct alignment of your satellite dish first.
5. We strongly recommend that the satellite dish antenna is installed by
a qualified satellite antenna installer.
Note: Product images are for illustrative purposes only and may differ from the actual
product.
Fig. 1
Fig. 2
En
Fig. 3
3