Zbeamz S553L Manuel De L'utilisateur page 6

We recommend a frequent cleaning of the unit, in particular the output nozzle.
There are no serviceable parts inside the unit except for the fuse. Repairs and service operations are only to be carried out by authorized
dealers.
Disconnect from mains before starting maintenance operation!
Ensure the fluid do not become contaminated.
•
Ensure the air vents are not clogged by dust. If necessary remove the dust.
•
• Ensure that the unit can not get overheated.
• Do not run the unit without any fluid, as the pump will run dry.
• Wipe up spilled Fluid immediately. Moisture and fluid can permanently damage the electrical components of the unit.
• If you install the unit make 100% sure that a permanent fog-free air supply for the unit is guaranteed. Cooling air with too high fog
concentration (very often in Clubs and Discos) can condense inside the unit and cause moisture damage.
For cleaning the surface of the unit use a suitable, solvent-free cleaner.
•
It is recommended to run the unit on a monthly basis in order to achieve best performance and output condition.
•
• Before storing, run Beamz cleaner fluid through the system to help avoid condensing the pump or heater.
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.