Publicité
Les langues disponibles
Les langues disponibles
CHANGING LAMP HEADS
The OPTIMAX Multi-Lite is available with three interchangeable,
single-wavelength LED lamp heads: UV-A, blue and white.
To remove or install a lamp head to the lamp base:
1.
Firmly hold the lamp base and lamp head.
2.
With the thumb and the forefinger, grip the
lamp head-locking ring and pull down (see
figure right).
3.
Remove or install the appropriate
wavelength lamp head in the socket by
pulling up or pushing down on the lamp head
and hold in place.
4.
Slide the lamp head-locking ring back into
place (covering the socket of the lamp head).
The grip will lock lamp head firmly into place.
IMPORTANT
When viewing UV fluorescence, use the flashlight in low-light conditions
to achieve the best inspection results. Wear the UV-absorbing spectacles
supplied for eye protection.
SPECIFICATIONS
DOMINANT
LED LIGHT
WAVELENGTH/
PART NO.
COLOR
COLOR TEMP
OUTPUT
AT 77°F (25°C)
OF-365AUV
UV-A
OF-450AB
Blue
OF-300AW
White
TECHNICAL SPECIFICATIONS
Product Number
Style
Lamp Head (diameter)
Length
Weight (with battery)
Light Source
Power Requirement
Continuous Run Time
Charge Time
TYPICAL
BANDWIDTH
OUTPUT
AT 700 mA
365nm
360-370nm
310 mW
450nm
440-460nm
480 mW
4,500-
6500°K
100 lumens
10,000°K
OPTIMAX™ Multi-Lite OFK-300A
Multiple-wavelength LED flashlight
with interchangeable lamp heads
2.0 in (5.1 cm)
9.0 in (22.9 cm)
15.4 oz (435.5 gm)
LED
3.6V, 2AHr NiMH internal
battery stick, rechargeable
90 minutes
5 hours
6
ELECTRICAL SPECIFICATIONS
A 3.6V, 2 Amp-Hour NiMH rechargeable internal battery stick is included. Typical
charge time is five hours with a continuous run time of 90 minutes.
ENVIRONMENTAL CONDITIONS
The OPTIMAX Multi-Lite LED forensic light source is designed to be operation
safe under the following conditions:
•
Altitude up to 2,000 m (6,562 ft.)
•
Temperature 5°C to 40°C (41°F to 104°F)
•
Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreas-
ing linearly to 50% relative humidity at 40°C (104°F)
•
Mains supply voltage fluctuations not to exceed ±10% of the nominal voltage
•
Installation Category II
•
Pollution Degree 2
CARE AND USE OF NICKEL-METAL HYDRIDE (NiMH) BATTERIES
•
NiMH battery packs last longer when charged and stored in a temperature
range between 50°F to 86°F (10°C to 30°C) away from heat, sunlight and
humidity.
•
Always charge batteries to full capacity before long-term storage
(approximately 30 days) to prevent aging. After storage they must be
charged, which may require conditioning (two or three charge/discharge
cycles) to reach full capacity.
•
Do not subject these batteries to repeated deep discharges that run the
batteries down completely on a regular basis as this will greatly shorten
battery life.
•
NiMH batteries generally have no voltage sag until the last 10% of charge.
The lamp usually will operate for better than 90% of the battery's rated
capacity.
•
NiMHs have no toxic lead or mercury, and a life expectancy of 500 charge/
discharge cycles or more, provided the battery is not overcharged or heavily
discharged. Recycle according to local disposal laws. Do not dispose of in
fire. They will explode.
7
Publicité
