UMBRA RIMORCHI TS NEXT 13156/1 Mode D'emploi page 7

Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar; then paint the
uncovered parts with rust preventer.
1.
2. Place the two components "B" on the lower, upper and inner side of the spars in correspondence to holes "1","2" and "3",
3.
4.
5. Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout.
6. Connect the wiring to the socket (usually given apart), following the car booklet s instructions "use and maintenance" as
shown in the enclosed wiring kit layout.
• Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehicle s towing
(umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
• For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
•
• The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at regular
intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow ball must be
replaced with a new one.
• After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
13156/1 • 1.0 • 29/09/2015
s version.
.
7