Jata electro JEGR1603 Instructions D'usage page 10

• This appliance is not intended for using with an external timer
or a separate system of remote control.
• To unplug, pull from the plug, never from the cable.
• It must not be used outdoors.
• The cleaning and maintenance done by users, can not be done
by children without any supervision, unless they are over 8
years and they are under supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
INSTRUCTIONS OF USE
• Before using for the first time, clean the grill with a damp cloth. Next, dry carefully and spread a little oil
with a cloth or kitchen roll.
• Before each use pour some oil on the grill.
• Place the appliance on a flat and heat resistance surface.
• The tray (6) must be in place, otherwise, the juices and fat resulting from the cooking will spill onto the
surface.
• Insert the connector (1) into the base (4), bearing in mind that the temperature selector (2) is in the top
position.
• Turn the temperature selector (2) to the desired position, according to the type of food you are going to
prepare using as a reference the selected temperature of the pilot light position (3). Firstly it is advisable to
put the selector to its highest position (nº 5), to let the grill reach, as soon as possible, a good temperature.
After that you can, if you consider it convenient, change the selector position.
• Plug into the mains. The pilot light (3) will go on. When the pilot light goes off the grill will have reached the
selected temperature.
• Place the food on the grill (5).
• Always use wooden utensils to move or turn the food over. The use of forks or other metal utensils may
scratch the surface.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, unplug the appliance from the mains and remove the connector from its
base.
• Do not wait for the grill to cool completely. The cleaning of the surface will be easier if it is still warm. It is
enough to use a slightly dampened cloth and if there were some difficult residues they may be cleaned with
little oil or
pass an ice cube repeatedly over the entire surface.
• It may be cleaned with soap and water, taking care to rinse carefully afterwards.
Important: If you have immersed it in water or rinsed with abundant water you must dry the base of the
connector (4) and the pins before using it again.
• Do not use abrasive or chemical products, metallic scourers, and such may deteriorate the protection.
• The tray (6) may be cleaned with water and detergent suitable for the dishwasher.
• The connector must always be cleaned with a dry cloth and must never be immersed in water.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
10