Blomberg IWD 1004 ET Mode D'emploi page 17

3. Take out the water filter by-pass cover
by rotating it downwards. (Figure 3-4)
A
Warning: Make sure that the "Ice off"
mode is active before taking out the by-
pass cover.
All manuals and user guides at all-guides.com
Note: It is normal that a few drops of
water drip after the cover has been taken
out.
4. Remove the lid on top of the water filter
to place it as shown in the figure and
turn upwards to lock it. (Figure 5)
5. Press ice cancel button on the display
again to exit from this mode.
Water filter should be replaced every
6 months. The water filter must be
removed as shown in the figure when it
is going to be replaced or when it will no
longer be used and by-pass cover must
be attached. It must be made sure that
Ice Off mode is active before taking it
out.
A
Warning: Water filter cleans some
foreign particles in the water. It does not
purify water from microorganisms.
A
Warning: Ice Off button must always
be pressed during replacement of the
water filter or installing the by-pass
cover.
3
1
16
EN
4
5
2