Alape HS.FO1250.R Instructions De Montage page 3

General information:
Please read the installation instructions before beginning with the installation!
Keep the installation instructions handy for further use.
All work should be performed by experienced, qualified personnel.
The manufacturer accepts no responsibility if these installation instructions are not followed.
The manufacturer accepts no liability and acknowledges no claims for damages or guarantee claims
concerning damages resulting from incorrect installation (e.g., insufficient wall reinforcement, insufficient
sealing against water splashes).
The installation materials are not included in the scope of supply.
Select installation materials to suit the wall.
Please observe and check the warnings.
Failure to observe the warnings can result in injury to the installer or third parties.
Failure to observe the warnings can result in material damage to the product.
These instructions do not replace national accident prevention regulations and the latter must always take
precedence over them.
In case of difficulties which cannot be resolved with the aid of the installation instructions, please contact
the manufacturer or supplier.
All installation and connection dimensions can be found in the planning documents.

There must be a fault current device at the place of installation (RCD: 30 mA 2-pin type A).
Important safety information in these installation instructions is indicated using symbols as follows:
Danger! Live current!

Indicates risks which can
result in severe injury or
death.
Work on live components must only
be performed by experienced,
qualified personnel!
Caution!
Ensure secure installation.
!
The on-site wall reinforcement must be verified.
Select installation materials to suit the wall.
The wall plugs for the installation are not included in the scope of supply.
Note!
!
It is essential to comply with the dimensions specified in the planning
documents.
Note!
! Uneven walls can create gaps which cannot be adjusted.
Prior to starting the installation, ensure that the wall is flat.
Smooth out uneven walls using appropriate means.
Alape˘ | A˘ system
Caution!
Indicates risks which can
!
result in material damage
or minor injuries.

Note!
! Indicates risks which
could possibly result
in material damage.
3 | 32
EN