Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
Adjusting low flame setting on cooktop burners
All Cooktop burner flames should be checked at their lowest setting. Use the
following steps to check and adjust the cooktop burner settings.
NOTES
• Low setting adjustments should always be made with two or more burners
operating at the same time.
• Call for service when you need to adjust the inner flame of the cooktop center
burner settings.
1. Turn on two or more cooktop burners and set them between MED and HI.
2. Quickly turn one of the control knobs counterclockwise to the lowest setting.
The flame should stay lit. If the flame flutters or goes out, adjust the bypass
valve on the control valve for that burner.
3. Pull the control knob for that burner straight off.
4. Using a small flat-bladed screwdriver, adjust the bypass valve screw in the base
of the valve stem. Turn the bypass valve screw counter clockwise to increase
the flame size.
Flat-bladed
screwdriver
Value Stem
5. Replace control knob and recheck the low flame setting.
6. Repeat step 1 thru 5 to check and adjust the low flame settings on the
remaining cooktop burners.
26 English
Install_NA9300K_DG68-00841A-01_EN+MES+CFR.indb 26
Inner flame
bypass screw
Outer flame
bypass screw
Dual valve
Combustion flame quality
1. Soft blue flames—Normal for natural gas
1
2. Yellow tips on outer cones—Normal for
3. Yellow flames—Abnormal for any gas
2
3
Additional low flame check
1. Quickly open and close the cabinet door while the cooktop burner is set on LO.
If the flame is extinguished, increase the low flame setting and repeat the test
until the flame is stable.
2. Turn the knob from HI to the lowest setting quickly. If the flame goes out at the
lowest setting, increase the low flame setting and repeat the test until the flame
is stable.
operation.
LP gas operation.
operation. Further adjustment required.
12/12/2016 9:31:47 PM
Publicité
