Hinkley 52 METRO ILLUMINATED Manuel D'instructions page 13

BLADE ATTACHMENT
NOTE:
The fan motor assembly is shipped with rubber supports
to prevent movement during transportation. Remove the
rubber supports from the fan motor assembly and
discard prior to attaching the blade arms.
Place Rubber washer on screw. Insert this assembly through
1
the blade and start the screw into the blade arm. Repeat this
procedure without tightening the screw until all 3 screws have
been started into the blade arm (Fig. 1).
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades (Fig.
2). Make sure screws are TIGHT! Loose motor screws can
contribute to unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are NOT recommended, as they
usually strip the heads of the screws and usually will not fully
compress the lock washers on the motor screws. Use a large
at blade screwdriver for nal tightening to fully compress th
washers. This will help ensure proper alignment of the blades
and noise-free, wobble-free running.
Screw
Rubber Washer
Blade Arm
Fig. 1
Rubber
Supports
Screws
Screws
Fig. 2
©2020 Hinkley Lighting, Inc. | hinkley.com |
Blade
Blades Assembly
11