KBS 202 Serie Mode D'emploi page 6

• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
Replacing the Lamp
1. Switch Off and disconnect the appliance from the power supply
2. Remove the plastic cover
3. Twist the lamp in its socket and release
4. Remove the lamp and replace the new one of the same power rating
5. Replace the plastic cover
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the
Helpline or your dealer.
Fault
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance turns on, Too much ice on the evaporator
but the temperature is
Condenser blocked with dust
too high/low
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is The appliance is not properly
leaking water levelled
The discharge outlet is blocked
Probable Cause
Check the unit is plugged in correctly and
switched on
Call agent or qualified Technician
Replace the fuse
Check power supply
Call agent or qualified Technician
Defrost the appliance
Clean the condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
UK
Solution
5