Publicité
Les langues disponibles
Les langues disponibles
US
Read all instructions before using or installing this product.
Technical data
– Supply voltage:
– Required electrical outlet:
– Max. power consumption:
Prod. No.:
11597 171050:
11597 171550:
11597 172050:
11597 172550:
11597 173050:
– Degree of protection:
– Ambient conditions:
Operating temperature
Storage temperature
– Luminous color
Mounting dimensions, see page 8.
Modes
The device can be operated in two modes.
Mode 1 (ex works):
Lighting On/Off at the device button (Off
automatically after power returns).
Mode 2:
Lighting On/Off at the external light switch (Off
automatically after power returns).
To change mode, see table under Operation:
Installation, see fi gure 1a/1b onwards on page 9.
Before installation check whether the fastening mate-
rials included are suitable for the anchoring base. The
fastening materials are suitable exclusively for stud walls
with timber constructions or for drywall constructions
with timber wood reinforcement.
• Mark the wall bracket position, see fi gure 1a/1b.
• Mount the wall brackets to the wall, see fi gure 2.
• Mount the light mirror fi xation, see fi gure 3.
WARNING - GROUNDING
INSTRUCTIONS
This product must be connected to a grounded me-
tal, permanent wiring system, or an equiment-groun-
ding conductor must be run with the circuit con-
ductors and connected to the equipment-grounding
terminal or lead on the product.
Wiring diagram, see fi gure 4 on page 10.
• Connect the light mirror to the power supply,
see fi gure 5a/5b on page 11.
• Remove the adhesive cover from the light mirror
fi xation, see fi gure 6.
• Hang the light mirror on the wall from above,
see fi gure 7.
120 V AC / 50/60 Hz
15 A / 1800 VA
Width
Weight
Light
21-1/16"
15.2 lb
27-15/16"
18.5 lb
41-3/4"
26.0 lb 19.5 W
55-1/2"
33.3 lb
69-5/16"
41.0 lb
NEMA 1
32° – 113° F
-40° – 158° F
4000 Kelvin
• Press the light mirror to the light mirror fi xation,
see fi gure 8.
Operation
Button functions
Button
Function
10 W
Light on/off
13 W
• Pressing the button switches the light mirror
on with the selected settings. The white LED
goes off.
26 W
• Pressing the button again switches the light
32 W
mirror off. The white LED lights up.
To change mode
• Switch off the refl ector.
• Press the button and hold it down for 15
seconds.
- The light comes on again if the mode has
Repeat the procedure described to re-enable
mode 1.
• The white LED can be deactivated.
– Switch on the light mirror.
– Press and hold the button for 15 seconds.
- The lighting gets lighter or darker.
- The lighting switches off briefl y and the
To switch the white LED back on, repeat the
described procedure.
Replacement parts with order numbers, see page 15.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions
and Warranty Card.
Disposal instructions
This category of device does not belong in
the domestic waste, but must be disposed of
separately in accordance with the relevant
local national regulations.
been changed.
white LED is deactivated.
3
Publicité
