Publicité
Les langues disponibles
Les langues disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (C) and
washer (B) from the new faucet (A).
□
Align the hole in the gasket (E) and deck plate
(D) with the mounting hole in the sink. Place
the faucet (A) through the deck plate (D) and
mounting hole in the sink until the faucet (A)
sets on top of deck plate (D).
□
Secure the faucet (A) to the sink using the
washer (B) and lock nut (C) provided.
NOTE: When you insert the lift rod (O), the lift rod (O) can
go through the faucet (A) and down into the slot of the
washer (B). If the sink is uneven, use silicone under the
gasket (E).
B
C
A
1
D
E
C
2
2
Preparing the pop-up assembly
□
Remove the pop-up stopper (F) and drain
ange (G) from the drain body (J).
J
4
F
G
Publicité
