Muse M-30 BT Manuel De L'utilisateur page 5

REPEAT PLAYBACK
Repeatedly press to select one of the following playback modes. Track Repeat, Repeat All and Repeat Folder .
TO DISABLE THE REPEAT PLAYBACK
Press repeatedly until the repeat mode indicator disappears from the display. The repeat function is automatically canceled at
the opening of the door of the CD or the shutdown of the unit.
PROGRAM PLAYBACK
1. Insert the disc with the label facing up, into the compartment and close the CD door.
2. Press .
3. Press .
4. Select the desired track with or then press
5. Repeat step 4 until the end of your programming.
6. Press to start playback. This PROGRAM function is automatically canceled when opening the CD door or shutdown of the unit.
Note:
CD up to 20 programs, MP3 up to 99 programs.
AUXILIARY INPUT ( AUX. IN)
1. Connect one end of the cable (not supplied) to the auxiliary input connector of the device.
2. Connect the other end of the cable to the headphones jack or the line out jack of your external audio appliance.
to select the auxiliary mode. « AUX » appears on the display. Normally use your external audio appliance; the sound
3. Press
automatically goes through the speakers of your device.
4. Adjust the volume to the desired level.
5. Disconnect the external appliance from the auxiliary input to stop playback.
LISTENING TO DEVICE USB
1. Press to turn the unit on.
2. Connect a USB device containing MP3 昀椀les or MP3 player to the USB port.
3. Press to select the USB mode. USB appears on the display.
4. After a few seconds, the total number of folders and tracks are displayed, and playback starts automatically.
NOTE:
- The total number of MP3 昀椀les on the disc should not exceed 999
- The disc may not contain more than 99 directories.
- The charging time takes about 20 seconds or more depending on the amount of MP3 昀椀les and folders on the disc or USB device.
- The USB port is not designed for charging and 昀椀les transfer with a computer
- Manufacturer is not responsible for the playability of USB key or MP3 due to di昀昀erent recording condition, capacity and interface
compatibility, etc...
MP3 FOLDER OPERATION
1. Press to turn the unit on.
2. Place the CD-MP3 disc with label side facing up inside the CD compartment and close the CD door, or, connect a USB key with
MP3 audio 昀椀les into the USB port.
3. Press to select CD or USB mode (CD or USB icon is displayed), After few seconds, the total number of folders and tracks
appears on the display. The unit will start to play automatically.
4. If there is more than one folder, press and hold
5. Press or to select the desired folder and release the
Playing automatically.
MAINTENANCE
CLEANING
CAUTION: Disconnect this device from any power source before cleaning.
- Use a soft, clean, dry cloth. Dust regularly ventilation holes on the back or sides of the apparatus.
- The use of solvents or abrasive products or with a basis of alcohol can damage the unit.
- If an object or liquid enters the unit, unplug it immediately and have it checked by an authorized engineer.
Notes on discs
* Do not use irregularly shaped discs (example : heart-shaped, octagonal ones). The unit may malfunction.
* Do not place more than one disc in the compartment.
* Do not attempt to open the disc tray during playback.
* Do not touch the lens. You could cause a malfunction.
* If the disc is scratched, dirty or smudged with 昀椀ngerprints, the device may not work. Before playing, wipe the disc with a cloth.
Proceed from the center outwards. Do not store discs in places with high temperature or high humidity. They could bend. After
reading, replace the disc in its case.
IMPORTANT NOTE
Remove the disc from its compartment if the device is to be transported.
RD-3353BTB IB MUSE 001 REV2.indd 5 RD-3353BTB IB MUSE 001 REV2.indd 5
to save the program in memory.
AUX IN
for 3 seconds, on the display "FXX" appears and " FOLDER" 昀氀ashes.
/ PAIR button to enter this folder. the 昀椀rst track in the folder starts
EN - 3
SPECIFICATION
POWER SUPPLY:
AC: 230V 50Hz
DC: 9V 6 x 1,5V type UM-2/R14/ 'C'
POWER CONSUMPTION: 14W
OUTPUT POWER: 2 x 1 WATTS RMS
RADIO
Frequency range
FM: 87.5 - 108 MHz AM (MW): 522 - 1620 kHz
BLUETOOTH
Bluetooth Version: V5.1
Bluetooth: 2.402-2.48GHz
RF Output Power: 0 dBm
Working Distance: Up to 10 meters measured in open space (wall and structures may a昀昀ect range of device)
Speci昀椀cations are subject to change without notice.
SAFETY
CAUTION: To reduce the risk of electric shock, do not disassemble this product. The unit contains no user
serviceable parts inside. Refer all servicing to a quali昀椀ed technician.
The lightning 昀氀ash with arrowhead within a triangle alerts the user to the presence of "dangerous voltage" inside the
product.
The exclamation point within a triangle to alert the user to the presence of important instructions in the literature
accompanying the appliance.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
ATTENTION: Invisible when safety devices are open or defective laser radiation. Avoid exposure to beam. Device class 1 laser.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
PRODUTO LASER CLASSE 1
ATTENTION!
- Ensure proper ventilation of the unit and do not cover the ventilation openings with items such as newspapers, tablecloths, curtains,
etc.
- Do not put any heat sources, such as lighted candles, on or near the appliance.
- Use this unit in a temperate climate.
- Do not expose the unit to dripping or moisture.
- Ensure a minimum distance of 5 cm around the unit to allow adequate ventilation.
- Do not place objects 昀椀lled with liquids, such as vases, on or near the appliance.
- The plate is located at the rear of this unit.
- The mains plug is used to disconnect the device and must be easily accessible. To completely remove power from the unit, unplug
the AC power plug from the outlet completely. The AC power plug cannot be constrained and must be easily accessible during use.
- As a result of electrostatic phenomena and / or electrical transients, the product may malfunction and reset may be necessary.
- Do not expose the batteries to excessive heat such as direct sunlight, 昀椀re or other sources of heat.
- Please respect the environment when disposing of used batteries.
- To prevent splashing, place objects 昀椀lled with liquids, such as vases, near the product.
- Under the in昀氀uence of fast transient and / or electrostatic electric phenomenon, the product may malfunction and the user must
perform a power reset of the device
- The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so, simply reset the product to
resume normal operation by following the instruction manual. In case the function could not resume, please use the product in
other location.
If you want to dispose this product, remember to recycle in a land昀椀ll for household electric appliances. Learn to know your
recycling center nearest you. Check with local authorities or your dealer for details. (Directive on Waste Electrical and
Electronic Equipment)
NEW ONE S.A.S
10, Rue de la Mission, 25480 Ecole Valentin, France
EN - 4
2023/5/16 17:04:09 2023/5/16 17:04:09