Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Removing the container
Fig. 4
Pull out the container all the way, lift at
the front and remove.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance!
When thawing frozen products, place
■
them in the refrigerator. Use
the coldness of the frozen food
to cool food.
Open the appliance as briefly
■
as possible.
Occasionally clean the rear
■
of the appliance to prevent an
increased power consumption.
If available: Fit wall spacers to obtain
■
the indicated energy rating of the
appliance (see Installation
instructions). A reduced wall gap will
not restrict the function of the
appliance. The energy rating may then
change slightly. The gap of 75 mm
must not be exceeded.
en
31