Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Load is wet at the end of
a cycle.
Leaks water.
Has odors.
A message appears on
the display to alert that
dispenser is open.
The "Refill Auto detergent
dispenser", "Refill Auto
softener dispenser", or
"Refill Auto detergent
and softener dispensers"
message does not
disappear after refilling
the detergent/softener.
64
English
Untitled-1 64
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
• Make sure the door is properly closed.
• Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and secured to
the drain system.
• Avoid overloading.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Check the drain hose.
-
Make sure the end of the drain hose is not placed on the floor.
-
Make sure the drain hose is not clogged.
• Excessive suds collect in recesses and can cause foul odors.
• Run cleansing cycles to sanitise periodically.
• Clean the door seal (diaphragm).
• Dry the washer interior after a cycle has finished.
• Check if the detergent drawer is closed properly.
-
Open the detergent drawer and close it again. Make sure it's closed
properly.
• After refilling the auto detergent/softener compartments, close the
detergent drawer, and then tap and hold
to detect the detergent/softener, and the message will disappear.
• Depending on the type of detergent/softener, the message may not
disappear immediately.
Action
. Then, the washer will start
2022-03-31
11:19:26
Publicité
