Philips AZT9240 Mode D'emploi page 20

RADIO
Radio play
You can tune to any FM or MW (or AM) station
automatically or manually. Stereo stations are indicated
by .
ST
1 Press RADIO·BAND to switch the radio on.
2 Press RADIO·BAND if necessary repeatedly to select
the desired waveband.
1, 2,
y
FM FM
Tuning to radio stations automatically
1 Keep 3 or 4 pressed for at least 1 second.
The radio tunes to a station with sufficient
y
strength and radio play starts.
A (for "automatic search") and the current
waveband and frequency are displayed.
2 Repeat searching until you find the desired radio station.
Tuning to radio stations manually
1 Keep 3 or 4 pressed.
2 Release 3 or 4, then briefly press 3 or 4 again
when you are close to the desired frequency.
3 Briefly press 3 or 4 repeatedly until you reach the
desired frequency.
Radio play starts. The current waveband and
y
frequency are displayed.
• To switch from radio play to CD play press 2;.
• Press 9 to switch the radio off.
Note: In case of interferences in stereo mode press · MODE to switch to mono.
20
3, 4 or
(or
FM FM MW
) is shown.
AM