1.
Plug the antennas in
•
Plug the 2 antennas of your choice (not included) into the Ant.1 and Ant.2
connectors.
•
For single antenna installation, use Ant.1 connector.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput, and as well as waterproofness.
2.
Connect the power supply
The device has 2 sources of power supply:
•
Power through M12 PWR connector
•
PoE through M12 LAN connector
See the "specifications" section about the characteristics of the power supply.
•
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power
•
ON if main power supply or PoE source is ON.
•
The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3.
Connect the Ethernet cable
•
Plug the Ethernet cable to the device's LAN M12 connector.
•
Check that the corresponding LAN LED turns ON at that point.
HARDWARE INSTALLATION
-
-
2