Publicité
Les langues disponibles
Les langues disponibles
Figure 4: Kona Micro Gateway Module Wall Mounting Orientation
Ensure that the wall on which the Gateway is being mounted is secure, flat and able to support a
load of at least 0.5 kg (1.1 lbs).
The Kona Micro Gateway wall mounting procedure is as follows:
1. Install the M3 screws into the wall.
2. Install 2 site supplied M3 screws into the wall at 60 mm (2.4") center spacing, leaving the
screw heads protruding with a 3 mm gap from the wall surface.
3. Hang the Kona Micro Gateway by mounting the two to keyhole slots onto the screws.
2.4 DC Power Cable Installation
The Kona Micro Gateway may be powered from the supplied AC-DC power adaptor. The adaptor
provides 12 VDC with positive inner tip as shown below in Figure 5. The connector tip is a
standard DC Barrel connector-straight plug with 2.1 mm (inner), 5.5 mm (outer) diameters.
Kona Micro Gateway User Guide
TEKTELIC Communications Inc.
T0008073_UG
Confidential
Version 1.1
Page 12 of 26
Publicité
