Power Failure; Light; Vacation And Moving Care; Moving - Impecca 10.2 CU. FT Manuel D'utilisation

POWER FAILURE

If there is a power failure, do not open the freezer door. Frozen
food should not be affected if the power is restored within sev-
eral hours.
If power is out for an extended period of time, check the food
for thawing.

LIGHT

TO REPLACE A LIGHT BULB:
NOTE: You may need to remove the top shelf to access the light
bulb.
1. Unplug refrigerator or disconnect power.
2. Remove the screw fastening the light shield, and then re-
move the light shield.
3. Remove the burned-out bulb and replace it with an appli-
ance bulb of the same size, shape and wattage.
• Replace with a 1.2 Watt (25 Watt Incandescent equivalent)
LED Bulb with candelabra base.
IMPORTANT: DO NOT replace with an incandescent bulb
greater than 10 Watts.
• The refrigerator compartment is considered to be a wet/
damp environment, and some LED replacement bulbs
are not recommended for wet/damp environments. Be-
fore installation, read and follow all instructions on the
LED packaging.
4. Replace the light shield.
5. Plug in refrigerator or reconnect power.

VACATION AND MOVING CARE

VACATION
If You Choose to Leave the Refrigerator On While You're
Away:
1. Use up any perishables and freeze other items.
If You Choose to Turn Off the Refrigerator Before You Leave:
1. Remove all food from the refrigerator and freezer.
2. Unplug refrigerator or disconnect power.
3. Clean refrigerator, wipe it, and dry well.
4. Tape rubber or wood blocks to the tops of both doors to
prop them open far enough for air to get in. This stops odor
and mold from building up.

MOVING

I WARNING
EXCESSIVE WEIGHT HAZARD
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL REFRIG-
ERATOR.
FAILURE TO DO SO CAN RESULT IN BACK OR OTHER INJURY.
When you are moving your refrigerator to a new home, follow
these instructions to prepare it for the move.
IMPORTANT:
• If possible, move the refrigerator in an upright position. If the
refrigerator must be moved horizontally, it must be placed
only on its right-hand side (as you are facing the front of the
refrigerator). After standing the refrigerator upright, wait at
least 12 hours to allow the system to settle before plugging in
the refrigerator.
1. Remove all food from the refrigerator and pack all frozen
food in dry ice.
2. Unplug refrigerator.
3. Empty any water in the drain tray.
4. Make sure that the defrost water drain tube at the back of
the refrigerator is attached to the drain tray on the top of the
compressor, to avoid defrost water spilling onto the floor.
5. Take out all removable parts, wrap them well, and tape
them together so they will not shift and rattle during the
move.
6. Wash and rinse the interior, and then dry thoroughly.
7. Raise the leveling legs so they don't scrape the floor. See
"Leveling."
8. Tape the doors closed and tape the power cord to the back
of the refrigerator.
9. When you get to your new home, put everything back and
refer to the "Installation Instructions" section.
–10–