RAVAK SONATA Serie Instructions De Montage page 3

MOUNTING INSTRUCTIONS
GB
FOR THE SONATA HANDLE
CONTENTS OF THE MOUNTING KIT - HANDLE
SONATA handle
Galvanized screw M8x35
Nut M8
Galvanized washer
This type of bathtub has been prepared by the manufacturer with pre-drilled holes for the installation
of a handle and headrest.
The handle must be mounted before installation of the bathtub.
It cannot be mounted afterwards!
In the center of the side part of the bathtub there are 2 x 2 pre-drilled openings (9mm in diameter) for
the 2 parts of the handle.
With the flat side up, place the handle against the pre-drilled holes. It should be seated to follow the
shape of the bathtub.
After finding the proper position, check that the holes in the bathtub coincide with the holes in the
handle. If not, the handle can be slightly pressed into the proper position.
Before final placement of the handle, place a small amount of silicone on the outer side of the holes,
under the washers. Put the handle in place and tighten the M8 screws and washers from the under
side of the bathtub. Tighten the screws normally. Over-tightening of the screws can cause
deformation of the handle.
tel.: 318 427 111, 318 427 200, fax: 318 427 269, 318 427 278, e-mail: smith@ravak.cz, www.ravak.com
The manufacturer reserves the right to change the price, technical parameters or other facts without
2 pcs
4 pcs
4 pcs
4 pcs
RAVAK a.s., Obecnická 285, 261 01 Pøíbram 1, ÈR
a prior notice and shall bear no responsibility for the printing errors.