Costway GY10010 Instructions page 5

Step 3:
Then install a No. 5 battery (AA battery) into the empty space of
the upper and lower battery bins to fill the battery bin.
- AA +
+ AA -
Step 4:
Cover the battery cover, turn the power switch to the "I" position,
and the blue indicator light will be on for 2 seconds to work
normally.
08
- AA +
+ AA -
Function introduction
1. This product uses infrared induction technology to control the
opening and closing of the barrel cover. When the product is
powered on, the blue indicator light will be on for 2 seconds. After
the indicator light is off, there will be an automatic cover closing
action, that is, it will enter the standby state.
2. Normal sensing function: the sensing area is about 30cm above
the sensing panel. When an object or hand is placed in the
sensing area, the barrel cover will automatically open. At this time,
the indicator light flashes. After 5 seconds, the barrel cover will
automatically close. At this time, the indicator light goes out and
the product enters the standby state.
3. Touch opening and closing function: when the product is in
standby mode, press the open key on the panel by hand, the
barrel cover will open automatically, and the indicator will flash
once every 5 seconds. At this time, the sensing function does not
work. You need to press the close key on the panel by hand to
close the cover, or wait for 10 minutes, the barrel cover will close
automatically, and the product will enter standby mode again.
Use of inner bucket and garbage bag
First remove the bucket head of the product, take out the inner
bucket / middle ring, open the garbage bag and put it into the inner
bucket / middle ring, roll the bag mouth to the outside of the inner
bucket mouth / middle ring, tighten and roll up the garbage bag,
plug it into the storage ring of the inner bucket / middle ring, and
then put the inner bucket / middle ring back into the bucket body.
09