Publicité
Les langues disponibles
Les langues disponibles
The walk-in bathtub can be installed and finished with tile or wall panel as shown in image above.
The walk-in bathtub deck design is flat, allowing for tile or wall panel to overlap the tile flange and
the deck for a proper seal and to have enough distance between the controls and the wall. It is
suggested to install the tile flange to the edge of the bathtub with 100% silicone before pushing the
walk-in tub against the wall into the place. Any thin (1/8" or 3/16") rustproof and waterproof
material like acrylic, thin stainless steel, or fiberglass strip can be used as a tile flange. A tile flange
can also be supplied by a contractor (available online). The strip can be approximately 5" tall, just
enough to be glued to the edge of the tub and overlap the edge by 2" giving enough water barrier.
Silicone-based caulking must be applied to joints.
NOTE: Any alterations or installed additions are the responsibility of the installer. Ella Accessible
Bathrooms is not responsible for any damage to the unit or for water damage, which could occur
due to improper installation.
ellasbubbles.com
Finishing the Installation of the
Walk-In Bathtub to the Wall
18 of 28
6/15/23
Publicité
