Troubleshooting Guide - XPower FC-100 Mode D'emploi

User Maintenance Instructions

Troubleshooting Guide

PROBLEM
Air Circulator does
not start
Unit runs but the
speed is abnormal
* These functions do not apply to all models mentioned in this manual.
If troubleshooting does not resolve your problem, please contact XPOWER or other
parties authorized by XPOWER for further instructions.
English - 10
Stack Multiple Units
• Stack the Air Circulators on the sides. Align the air
inlets of both Air Circulators.
!
WARNING
• For model FC-100 / FC-200 Series, DO NOT stack
more than six units of this appliance.
• For model FC-300 / FC-420, DO NOT stack more
than five units of this appliance.
• Stacking function is not secure during
transportation.
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
The circuit breaker on the
additional electrical receptacle
(Daisy chain) jumps.*
The timer switch is set to "0"
position.*
Air inlet or air outlet is blocked.
(Continued)
SOLUTION
Check for power supply.
Remove and reconnect the
power cord.
Remove all appliance on
the additional electrical
receptacle and press "Reset".
Set the timer switch to "ON"
position.
Remove blockage.