Télécharger Imprimer la page

Aquaglide EL JEFE TR Manuel Du Propriétaire page 10

Plate-forme de saut

Publicité

Les langues disponibles

Les langues disponibles

18. If El Jefe Climbing Wall accessory is to be included, install this item. See instructions for Climbing Wall
assembly and installation for details.
19. If El Jefe Trickler Kit is to be included, install this item. See instructions for El Jefe Trickler Kit assembly
and installation for details.
20. Confirm that suitable anchor(s) and mooring lines are in place before launching this item (see
Anchoring). To launch product, carefully slide into water making certain to clear the path of any protrusions
that could damage it. Large items such as this will require several people to accomplish this. Be prepared
with towing and control lines once the item is launched. To prevent damage and potential injury, never tie
this product to a dock. Always take the item immediately to it's intended anchorage and secure.
21. Once El Jefe is floating and secured in its intended anchorage, double check for proper tension on all
lower connecting straps. This is best done by experienced swimmers/ divers. All straps should be as tight
as possible, with no gap remaining between the base and boarding or slide connections.
22. This item is commonly used as part of a modular system. Boarding this item is done using a variety of
boarding features sold separately. When connecting multiple items together, always follow manufacturer's
recommendations. Use only Aquaglide Two-Step Vario-lock cinch straps and connecting rings. Make sure
connection is tight and there is NO GAP between items. Failure to connect items properly may result in
injury or death. See E1 - E6.
a. Attach straps to 'Boarding Features' (example: Swimstep, Splashmat, Speedway, Breezeway or
Deck) where a connection is required. Boarding Features should not be attached to other Boarding
Features.
b. Use all available rings to make connection. Standard connections use 5 rings. Some items use 3 or
occasionally 7 rings/ straps. El Jefe is a Main Feature item with 5-ring connections on 3 sides.
c. Float 'Boarding Feature' into desired position. Note: a matching set of connecting rings is required
on feature item.
d. Attach center strap to center ring on feature item. Connect loosely, then work outward until all
straps are connected.
e. Dive beneath to tighten all straps securely. Dive mask and several attempts may be required.
10
Connecting Strap instructions
E-1
E-4
E-2
E-5
E-3
E-6
www.aquaglide.com

Publicité

loading