Publicité
6
AFTER WATER CONNECTION
A. Installer must supply hot and cold water supply connections to the
valves.
B. When the connections are made , turn on both your hot and cold
valves. Check all joints for leaks. Tighten as needed.
C. Flush out both lines again before you thread your aerator (20) back
into the spout.
D. Turn on your hot and cold valves and with the water now running
from the spout (2), pull up on the diverter (1) to verify that the water is
now diverted properly to the hand shower. Now turn off the hot and
cold valves and the spring loaded diverter will return back to spout.
Only use the diverter to divert from the spout to the hand
shower. Do not divert back and forth with the water running.
Use only as instructed.
last revision: 05/21/2013
XCHANGE
xsquare X7618
4-piece deckmount tub filler with handshower
robinet de bain 4 morceaux avec douchette
Deckmount 4pc tub set
TAKING CARE OF YOUR AQUABRASS PRODUCT
To clean your AQUABRASS faucet or accessory, wash with a wet non-
abrasive soapy cloth. Then wipe dry with a soft towel or cloth .We
recommend this be done on a regular basis.
DO NOT USE ANY ABRASIVE , CHEMICAL OR CORROSIVE, POWDER
OR ANY OTHER STRONG CLEANERS INCLUDING DETERGENTS, WIN-
DOW CLEANERS AND DESINFECTANTS ON YOUR AQUABRASS PROD-
UCT as they will destroy the finish and therefore VOID THE WARRAN-
TY. Toothpaste remnants should also be rinsed off when necessary.
Ask your plumbing retailer about our PROTECTANT-CLEANER now
available from AQUABRASS. This product is specially manufactured to
clean and polish leaving a protective coating to maintain your products
shine and finish.
IN-XCH18-3-E
Updated 30-06-05
aquabrass.com
Publicité
