Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
To Attach Polishing Pad with Hook and
Loop Backing Pad (Fig. A, D)
1. Insert the centering tube
hook and loop backing pad
2. Line up the center hole on the hook and loop pad
with the centering tube
hook and loop backing pad
3. Screw backing pad
onto spindle
19
depressing spindle lock button
To Remove Pads
Turn them by hand in the opposite direction from normal
rotation to allow lock button to engage spindle, then
unscrew pads in normal direction for right-hand thread.
Fig. D
18
19
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
1
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
10
17
into the center hole in the
19
.
18
17
and attach the pad to the
.
19
, while
8
6
.
17
into the tool handle, align the
Fig. E
2
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
20
and one hand on the auxiliary handle
hand on the main handle
20
handle
.
12
Fig. F
Variable Speed Trigger Switch (Fig. A)
These tools are equipped with a variable speed trigger
switch that permits speed control from 0 to 2200 RPM.
To turn the tool on, squeeze the variable speed trigger
switch
shown in Figure A until the tool starts to run. The
5
farther you depress the trigger, the faster it will operate.
Releasing the trigger turns the tool off.
Use lower speeds for applying compounds, and higher
speeds for polishing. Use the highest speed (fully depress
trigger) for buffing the car to a final lustre.
The tool can be locked on for continuous use by squeezing
the trigger switch fully and depressing the lock button
shown in Figure A. Hold the lock button in as you gently
1
7
or one
and one hand on the bail
20
7
20
12
11
Publicité
Table des Matières
