Home Decorators Collection HDC6453B Guide D'utilisation Et D'entretien page 6

Installation (continued)
4
Attaching the fixture body to the outlet
box
□
Line up the holes on the backplate and mounting holes on the
folded edge of the crossbar assembly (AA).
□
Secure the fixture body (A) by threading the lock screws (DD)
into the mounting holes on the crossbar assembly (AA).
□
Thread one lock screw (DD) into the first side. Do not fully
tighten.
□
Thread the other lock screw (DD) into the other side and
tighten with a screwdriver.
□
Tighten the first lock screw (DD) with a screwdriver.
AA
DD
6
Installing the bulb
□ Install the correct bulb (not included) referring to the fixture
markings and/or labels for maximum wattage.
NOTE: Use one 60W maximum medium base (E26) type "S"
or 8W maximum medium base (E26) self-ballasted LED
vintage Edison bulb (sold separately).
5
□
□
□
DD
A
7
□
□
□
6
Installing the shade
Remove the socket collar from the socket on the fixture
body (A).
Place the shade (B) over the socket on the fixture body (A)
as shown.
Secure by threading the socket collar onto the socket.
Hand tighten until snug.
Using silicone sealer
Make sure the surface of the exterior wall and the fixture
backplate are free of dirt.
Using silicone sealer (not included) start on one side of the
fixture backplate and follow the contour where the fixture
backplate meets the exterior wall surface.
Proceed to seal around backplate.
NOTE: To ensure proper moisture drainage, do not seal
bottom of fixture backplate.
A
B
Socket collar