Home Decorators Collection HDC6453B Guide D'utilisation Et D'entretien page 5

Installation
1
Preparing the crossbar assembly
□ Unscrew the two lock screws (DD) from the fixture body (A).
Remove the crossbar assembly (AA) from the fixture body (A) and
keep the crossbar assembly (AA) and two lock screws (DD) for
later use.
AA
DD
3
Making the electrical connections
* Use wire connectors (CC) to connect the wires.
□
Wrap the supply ground wire around the green ground screw on the crossbar assembly (AA), no less than 2 in. from the end of
the wire. Tighten the ground screw.
□
Connect the fixture ground wire to the supply ground wire with a wire connector (CC).
□
Connect the supply white wire to the white fixture supply wire with a wire connector (CC).
□
Connect the supply black (or red) wire to the black fixture supply wire with a wire connector (CC).
□
Wrap each connection with approved electrical tape and carefully insert all of the connected wires into the outlet box.
CC
AA
Green Ground Screw
2
Installing the crossbar assembly
□
Align the crossbar assembly (AA) to the outlet box so that the two
mounting holes on the crossbar assembly (AA) are on the horizontal.
□
Secure the crossbar assembly (AA) to the outlet box (not included)
with outlet box screws (BB).
NOTE: Prior to installation, close or cover the sink drain
and/or any vents near the installation site to prevent loss of
mounting hardware if dropped.
DD
A
Outlet box
5
Please contact 1-800-986-3460 for further assistance.
AA
Mounting holes
BB
HOMEDEPOT.CA