Home Decorators Collection PEMBERTON CF52PEM5BK Guide D'utilisation Et D'entretien page 7

Assembly
1
PREPARING FOR MOUNTING
□
Release the mounting bracket (A) from the canopy (B) by
losening the four screws (marked "a" and "b" on diagram)
and washers.
b
Washer
a
B
□
Remove the bolt, flat washer and cotter pin on the yoke.
□
Position the downrod (C) / canopy (B) into the yoke and align holes
in the yoke and downrod (C).
□
Insert a bolt through hole in the yoke and downrod (C). Be careful
not to damage or cut the fan wires.
□
Tighten the flat washer and bolt. Secure with the cotter pin through
the hole in the end of the bolt.
□
Secure the downrod (C) in position by tightening upper jam screws.
Bolt
D
C
Upper
jam screw
A
Washer
b
a
Washer
B
Cotter pin
Flat washer
E
2
ASSEMBLING THE FAN
a. DOWNROD MOUNT
□
Use a Philips screwdriver to loosen the two upper jam screws
on the yoke. Do not losen the two lower jam screws.
□
Position the downrod (C) inside the canopy (B) and yoke cover (D).
□
Route wires exiting the yoke on the motor (E) through the ceiling
canopy (B) and downrod (C).
Yoke
b. FLUSH MOUNT
□
Remove the rubber ring from the canopy (B).
Rubber Ring
7
Please contact 1-800-986-3460 for further assistance.
B
D
C
Upper jam screw
Lower jam screw
B
HOMEDEPOT.CA