Publicité
Les langues disponibles
Les langues disponibles
Operation instructions
- Connect the lens cable to the lens cable port on the bottom of the device and tighten the
lens cable screw to secure.
- Do not connect the lens cable to computers, USB ports, or USB extension cables as doing
so will damage the device. The lens cable is not a standard USB cable.
- Make sure the lens cable installed behind the lens is untangled before powering on the
device.
- Do not detach the lens in non-Handheld Mode. Please refer to the <Mode Switch> chapter.
- When installing the lens in Handheld Mode, make sure the lens is securely inserted into
the lens holder and the latch is properly locked. Please refer to the <Mode Switch>
chapter.
- Use the device with care. Do not operate the device beyond its designed limits to avoid
damage.
Always use the supplied power adapter and power cord to connect the device to a
power outlet
- Before installation, make sure to disconnect the device from a power outlet.
- Install the device near the power outlet to make sure the power plug can be plugged and
unplugged from the power outlet easily.
- To avoid electric arc from damaging other electrical components, connect the power cord
to the DC 12V power jack on the device before connecting to a power outlet.
- The length of the power cord should be less than 3 m.
- Do not place the device where the cord can be stepped on as this may fray or damage the
cord or the plug.
Publicité
