Before First Use; Removing The Insulation Strips; Operation; Inserting/Replacing The Batteries - Miomare HG01030A Instructions D'utilisation Et Consignes De Sécurité

Risk of equipment damage
Only use the specified bat-
tery type!
When inserting the battery
ensure the correct polarity!
This is shown in the battery
compartment!
If necessary, clean the bat-
tery and de vice contacts
before inserting the battery!
Remove dead batteries from
the device immediately!

Before first use

Removing the
insulation strips
Note: The product is supplied
with the batteries already in place.
Remove the insulating stripes
from the battery compartment
before first use.
6

Operation

Inserting/replacing
the batteries
M ake sure the soap con-
tainer is empty and the
3
ON / OFF switch
"OFF"-Position.
O pen the battery compart-
ment (see Fig. B).
6
I nsert four 1.5 V
(AAA) (included) into the
battery compartment
(see Fig. C).
Note: Make sure you fit the
batteries the right way round
(polarity). The correct polar-
ity is shown inside the battery
compartment
T hen close the battery com-
partment again.
6
Filling the container
with soap
Make sure the soap con-
tainer is empty and the
3
at
5
batteries
6
.
6
GB/IE/NI 9