Publicité
Les langues disponibles
Les langues disponibles
•
Before use, make sure that
your hair is fully dry. Hair is
most fragile and prone to
breakage when it is wet. If
you use the appliance on
damp hair, the cuticle will be
opened and the cortex will
be damaged.
•
Do not bring the appliance in
contact with artificial hair.
•
Do not cover the air outlets
with clothes, hair or hands.
•
The brush of the curling
attachment becomes very
hot during use. Only hold the
brush at the front by the
brush cap.
Cleaning and maintenance
Before you proceed, we need you to pay
attention to the following notes:
-
Before cleaning or maintenance, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
-
Do not immerse the appliance in water or
any other liquids.
•
Regularly check the appliance for possible
damage.
•
Clean the outside of the appliance with a
soft, damp cloth. Thoroughly dry the outside
of the appliance with a clean, dry cloth.
•
Remove the hairs from the curling
attachment using a soft brush. Clean the
curling attachment under running water.
Thoroughly dry the curling attachment
with a clean, dry cloth.
Description (fig. A)
Your 520002/520003 Petra hair curler has
been designed for curling and waving your
hair. The appliance is equipped with two
curling attachments (16 mm / 20 mm). The
appliance is suitable for indoor use only. The
appliance is suitable for domestic use only.
1. Temperature switch
2. Roll-out button
3. Curling attachment
4. Handgrip
Assembly (fig. A)
Before you proceed, we need you to pay
attention to the following notes:
-
Before assembly or disassembly, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
Mounting and removing the curling
attachment (fig. A)
•
To mount the curling attachment (3), slide
the accessory over the front of the
appliance until the roll-out button (2) clicks
into place.
•
To remove the curling attachment (3),
keep the roll-out button (2) pressed and
pull off the accessory with a slight twist.
Use (fig. A)
•
Mount the curling attachment (3) to the
front of the appliance.
•
Insert the mains plug into the wall socket.
•
To switch on the appliance, set the
temperature switch (1) to the "1" or "2"
position. For cool air, set the temperature
switch (1) to the "COOL" position. Refer to
the table below for the correct settings.
The appliance starts heating.
Hair texture
Bleached, fragile, damaged or fine hair 1
Normal hair
Very coarse, thick or curly hair
5
Recommended
setting
1/2
2
Publicité
